( Copy & paste the "string" when generated above into the "Options= field" in your device. )

Options Calculator by Jim Nessen K6JWN.

Explanation.

DMR Gateway / MMDVM

Options="DIAL=2350;VOICE=0;LANG=en_GB;SINGLE=0;TIMER=10;"

*If you set a Static Talk Groups on Slot 1, YOU CAN not use it via Dial-a-TG.
Static Talk Group must be used via a Channel in your radio and not via Dial-a-TG.
Example:- If you set TG 2350 as Static, you can not use Dial-a-TG to talk on 2350.

TS1=2359;

Set Static you want on Slot 1.
You can not have the same Talk Group set as static on Slot 1 or Slot 2.
At the end of each section, you need a Semicolon.

DIAL=2350;

*see above

0=None. Set default Enhanced Talk Groups (Dial-a-TG) TG9 Slot 2.
Only One Talk Group can be entered in this section.
You can not have the same Talk Group set as static on Slot 1 or Slot 2.
At the end of each section, you need a Semicolon.

TIMER=10;

Time a Talk Group is held active for.  Pressing your PTT on a Talk Group reset this timer.
You select any number of minutes you like here.  But the recommended time is 10 or 15 mins.
If setting more than one static to slot 1, you might wish to set Timer lower.
At the end of each section, you need a Semicolon.

VOICE=0;

0=OFF  1=ON.  15 minute Voice Ident can be set ON or OFF on Time Slot 2.
Radios will RX from the network, "This is CALL-SIGN FreeDMR. "
At the end of each section, you need a Semicolon.

SINGLE=0;

Turn off Single Mode. Network default is ON. 0=OFF  1=ON.
At the end of each section, you need a Semicolon.

LANG=en_GB;

Set the Language the VOICE comes back to you as.  en_GB=Servers Default.
At the end of each section, you need a Semicolon.


Each section is separated with a Semicolon. "Does not matter what order the above codes are in".